Before the Work
The engineered wood floor at this property in Bow, E3 had seen considerable daily wear. Surface scratches were visible across the main traffic routes, the finish had dulled and was lifting in places, and the overall appearance of the floor had deteriorated to the point where restoration was clearly the right course of action. Furniture was moved from the working areas before the assessment began. The wear layer thickness was measured carefully — this is the critical check on any engineered floor before sanding, as the wear layer determines how much material can safely be removed. Board condition, adhesion and the existing finish were all reviewed before the scope of work was agreed with the client.
Our Approach
Furniture was cleared from the working areas before sanding began. The engineered floor was sanded using a Bona belt sander with a controlled fine-to-medium sequence, working with the grain throughout. Engineered wear layers are thinner than solid wood — typically between 3mm and 6mm on quality boards — so passes were kept measured and depth was checked regularly to avoid breaking through to the core layer beneath.
Once the surface scratches and old finish had been fully removed, the floor was buffed with a fine mesh pad to create a smooth, consistent surface ready for finishing. Three coats of water-based lacquer were applied, with a light sand between each coat. Water-based lacquer was the practical choice here — it dries quickly, has low odour and does not yellow over time, which matters in a property that needs to remain liveable throughout the process. All furniture was returned to position once the final coat had cured sufficiently.
The Result
The restored engineered floor looks as it should — clean, warm and even from wall to wall. The grain and natural colour of the timber are clearly visible now that the old build-up of finish has been removed, and the new lacquer coat gives the surface a durable, consistent sheen throughout. All work was completed to specification and signed off by the client on the day. Typical costs for engineered floor sanding and restoration in East London range from £25 to £45 per square metre depending on floor condition, wear layer thickness and the finish selected.
Frequently Asked Questions
Is engineered wood flooring common in Bow and the E3 area? Yes. Bow and the wider E3 postcode have seen significant residential development and renovation over the past two decades, and engineered wood is one of the most popular flooring choices across both period conversions and newer builds in the area. It handles the varying subfloor conditions found across East London well and is a practical, good-looking option for busy households.
How do you know if an engineered floor can be sanded? The key factor is the thickness of the wear layer — the solid timber top layer that sits above the plywood core. Most quality engineered boards have a wear layer between 3mm and 6mm, which allows between one and three full sandings depending on how much material is removed each time. Boards with a 2mm layer can usually only be lightly buffed. We always measure the wear layer before quoting so there are no surprises.
How much does engineered floor sanding cost in Bow? Sanding and restoration in the E3 area typically ranges from £25 to £45 per square metre, depending on floor condition, wear layer thickness and the finish chosen. We provide a full written quote after a free site visit with no obligation.
Do you cover Bow and the surrounding E3 area? Yes. We work regularly across E3 and the nearby postcodes, including Mile End, Stratford, Poplar and Bethnal Green. Call us on 020 88309782 or book a free site visit to discuss your floor.
Have a similar project? Call us on 020 88309782 or Book a Free Site Visit
Close